The Parameters - Lexicon MPX NATIVE REVERB PLUG-IN Owner's Manual

The Parameters

Reflection Level –
This knob controls the level of the early reflections in the
output mix.
Reverb Level –
This knob controls the level of the reverb tail in the output mix.
Color –
Color is the companion parameter to Rolloff. Rolloff filters the final output
of the reverb, and is used for final matching of the reverb into the mix. Color controls
the way the reverb evolves over time. The darker values mean that high frequencies
don't reverberate as long as lower frequencies. The lighter values lower the relative
reverb time of the lower frequencies. This parameter can be used to tame the way
an instrument is reverberated. For example a 24" kick drum will have a lot more low-
frequency sound than a 20". This might cause the reverb to be boomy. Selecting a
lighter value for Color will help to get that under control.
Rolloff –
One of the most important aspects of a good mix is to correctly set up
the proportion of frequencies. Getting reverb right is a major component of this
process. The rolloff filter allows the higher frequencies of the reverb to be reduced.
Most natural reverberation will be best modeled with a rolloff in the 2-4K range. Some
mixers searching for a vintage sound might even use lower values. For smaller rooms
or special effects, raise the rolloff value.
Diffusion –
Input diffusion is the first part of processing for any signal entering
a reverb or delay. It can be described as a smearing or softening of the signal and is
typically used to lessen the impact of strong transients. Sharp percussive sounds will
benefit from higher diffusion values. Vocal sounds will usually work best with lower
values.
14
9
MPX Native Reverb