Transferring From Dio 2448 To Dat, Monitoring With Dat - M-Audio Delta DiO-2448 Manual

Transferring From DiO 2448 TO DAT, Monitoring with DAT

DAT
SOUND SYSTEM
1. Connect the DiO 2448 coaxial S/PDIF output to the DAT coaxial S/PDIF
input using a good quality digital cable.
2. Connect the DAT analog outputs to some type of amplified sound
system. The sound system should be equipped with speakers or
headphones.
3. Open the DiO 2448 Control Panel software. Within the control panel,
verify that "SPDIF-OUT Source" is set to "WAV (software)." This routes
data from your recording software to the S/PDIF outputs.
4. Within your recording software, select "DiO-2448 Playback" as the
audio output device.
5. Start your DAT recording, then start your software program playing.
You should be able to hear the DAT outputs through your sound system.
This verifies that the digital audio is making it into the DAT correctly.
6. Stop your DAT when the recording is complete.
Coaxial In
Analog Out
16
Coaxial
OUT IN
R L OUT
DiO 2448
Out
IN