Getting Started/Assembly; Handlebars; Front/Rear Grill/Guard; Battery - X-TREME XA-112 Product Manual

GETTING STARTED
Please read and understand these instructions and the OPERATING
PROCEDURES section, prior to starting or riding your XA-112
Assembly
1. Carefully remove the XA-112 from the box.
2. Your XA-112
handlebars folded for shipping.
rotate the handlebars to the desired
up-right position and secure in place using
the enclosed bolts as shown. First lay clips
on the bracket then fit it on the top of the
handle bar, you can then fit bolts through
clips then screw into the ATV bracket.
Leave loose until all 4 bolts are started and
then tighten when in position desired.
3. Your XA-112 also comes with the front
bumper/grill detached for shipping. Begin
by locating the 4 bolts. Next, attach the
left and right bracket to the ATV frame as
shown and secure with the supplied bolt as
shown.
4. Install the rear guard using the supplied
bolts as shown.
5. Install the battery, located under the seat.
To remove the seat, use the latch located
under rear of seat. Red wire attaches to (+)
terminal and Black wire to (-) terminal.
9
Page10
may comes with
Simply
the