Sharp SJ-P43N-SL Service Manual page 21

(2)-2 Insert the terminals of Lead EV-cover ass'y to
Fan motor.
(2)-3 Fix two Motor cushions to Fan motor, and set it
at Fan motor holder A and B.
Then fix with Tapping screw.
Motor cushion
Fan motor
holder A
Lead EV-cover ass'y
Figure A-8
(3) Setting of Fan motor ass'y , Defrost thermo. ass'y and Fuse ass'y.
Lead e.v cover
ass'y
E.v cover sealer C
Take out lead wire
from square hole to
front and fix with
L-band C, then seal
with E.v cover sealer C
Aluminum tape
E.v cover sealer F
Turn up lead wire
Detail of G
Fan motor
holder B
Tapping
screw
Fan motor
RED
BROWN
E.v cover
Tapping screw
L-band C
Tapping screw
Set metal side below
G
H
H
Fuse ass'y
Aluminum tape
E.v cover AL A
[back side]
Fuse ass'y
ATTENTION
E.v cover
sealer E
SEC. H H
[Front side]
Figure A-10
(2)-4 Set Fan clamp to Propeller fan 100 and insert
it to the shaft of Fan motor.
D
Fan clamp
Propeller
fan 100
+
4 0.5mm
Shaft
Detail of D
Figure A-9
more than 3.5mm
Aluminum tape
L-band C
F
F
Defrost thermo.
ass'y
Defrost thermo.
ass'y
Aluminum tape
L-band C
E.v cover sealer E
21
Fan clamp
Slit of each Fan clamp
and Propeller fan
should not be at same position.
Slit
Fan clamp
Propeller fan
Note
Propeller fan should not be
taken out from shaft when
pulled by 3 kgf.
more than 3.5mm
[front side]
CUT
Not come out of claw.
SEC. F F
SJ-P43N/43N
SJ-P47N/47N