Kyocera Sprint DuraCore User Manual page 51

2. Highlight a group and press the DC button to begin the Group Connect call.
3. Continue the Group Connect call in the same manner as a one-to-one Direct Connect
call.
Note: Only one person at a time may speak on a Group Connect Call.
4. When you are finished, press
Connect call that you initiated, all other participants are dropped from the call. To change
this option, see
Note: If you get an error message saying that your contact ―is not reachable via Direct
Connect‖ or ―this number is not DC capable,‖ please check to see that you have entered
or highlighted a valid Direct Connect number.
Note: Currently Sprint phones do not support Group Connect calls with Nextel and
PowerSource phones. This enhancement is planned for future implementation. If your
calls are not going through, please check to see whether your contact is using a Sprint
phone.
Make a Group Connect Call From History
1. Press > History.
2. Highlight a group entry and press the DC button.
3. Continue the Group Connect call as described previously.
Make a Group Connect Call Without Saving
1. In standby mode, press
2. Press START (left softkey) to add Contacts entries with Direct Connect–capable
numbers to the group.

When adding a contact for the Group Connect call, make sure you highlight the
entry's Direct Connect–capable number (DC Only or Mobile+DC).
3. When you have finished selecting entries, press the DC button.
4. Continue the Group Connect call as described previously.
Join or Rejoin a Group Connect Call
If you are not available at the beginning of a Group Connect call, or if you drop off the call
temporarily, you can rejoin an in-progress Group Connect call.
1. Press > History.
2. Highlight the call and press the DC button.
Sprint Direct Connect
to end the call. (By default, when you end a Group
Set Group Termination
> Contacts > Add New > New Group.
Options.)
43