Configure Network Parameter - Kogan KAIPC01BLKA User Manual

Note:
After you click the search button the software will automatically search for all the
devices' IP addresses within a local area network.
There are three cases:
1. IP cameras' IP address is not found. After you clicked the search button the
devices' IP address did not show in the software's list: e.g. Figure3.1
2. IP camera's IP address is found, but the IP Camera's network segment is not
the same as the local IP address'. To fix this you should change the IP Camera's
network segment to be the same as the local IP address'. You can change this
following 3.1.1 Configure Network Parameter e.g. Figure3.4 (e.g. The local
computer's IP address is :192.168.0.15 but the device's IP address is:
192.168.1.99. You need to change the device's IP address:192.168.1.99
to:192.168.0.99)
3. IP cameras' IP address is found and the device's network segment is the
same as the local IP address. All devices are listed in the software list.
Note:
1. If it needs manual modification- camera name, HTTP interface, IP address,
sub-net mask, gateway, main DNS server, backup DNS server, etc. Click apply
after modification, enter IP camera username and password and click OK to
confirm.
2. Inner visit address is the LAN address; outer visit address is WAN address.

3.1.1 Configure Network Parameter

First select the device's IP address. Right-click to open the network configuration
dialog box, and from there you can configure the devices' network parameters.
Figure3.3
9