Fm Mode; General Operation; Scan Setting; Audio Setting - Kogan KGNDRVDA User Manual

FM Mode

General Operation

∗
1. Press MODE repeatedly until < FM Radio > is showing up.
For initial use, it will start at the beginning of the FM frequency range (87.50MHz). Otherwise, the last
listened FM station will be selected.
@
Note: Or enter < Main menu >, and then turn the SELECT knob to < FM >, press this knob to confirm
2. To manually adjust frequency, while frequency shows up, turn the SELECT knob to adjust it by
0.05MHz per step.
3. To auto-searching, while frequency shows up, simply press the SELECT knob
@
Note: a. To 'auto-searching' the next active station, repeat above step 3.
b. The unit will display the frequency changing until it stops on the next station.

Scan Setting

∗
þ By default, FM scans stop at any available station. This may result in a poor signal-to-noise ratio
(hiss) from weak stations.
þ To change the scan settings to stop only at stations with good signal strength, press and hold MENU
à < Scan setting > à Strong stations only? à Yes, press the SELECT knob to confirm.

Audio Setting

∗
þ By default, all stereo stations are reproduced in stereo. For weak stations, this may result in a
poor signal-to-noise ratio (hiss).
þ To play weak stations in mono, press and hold MENU à < Audio setting > à Listen in mono
only? à Yes, press the SELECT knob to confirm.
17
.
.