Boss BR-1200CD Owner's Manual page 221

6. Press [F1] (INSERT).
A new song will be inserted.
7. Use the TIME/VALUE dial to choose the song that you
want to write.
fig.05-131d
8. Move the cursor to the right to display the screen, and
then use the TIME/VALUE dial to set the V-Track that
you want to write.
fig.05-140d
At this time, "MASTER V-TRK" will be indicated for the
V-Track that was most recently used for mastering (i.e.,
the final mastering track). This can be used as a guide for
setting the correct V-Track.
Only stereo tracks can be selected for writing, and you
will not be able to select mono tracks at this time.
9. To cancel selection of a song, press [F2] (DELETE).
The selection will be canceled.
10. To insert a song just before a song that has already
been selected, move the cursor to the position you want
to insert, and then press [F1] (INSERT).
A new song will be inserted.
11. Repeat Steps 6 through 10 to select all of the songs you
want to write, and then press [F3] (GO).
The Write Speed screen will appear.
12. Use the TIME/VALUE dial to set the write speed.
Alternatively, if you want to use the write speed that is
currently displayed, proceed to Step 13.
13. Press [ENTER/YES].
The message "Write Sure?" will appear.
14. Press [ENTER/YES].
The message "Now Writing..." will appear and writing
to the audio CD will begin. When this process has been
completed, the finalization will start automatically.
When the message "Complete!" appears, it indicates that
writing has been fully completed.
15. Press [EXIT/NO] several times to return to the top
screen.
16. Press the CD-R/RW drive's EJECT button to eject the
disc.
This completes the writing process.
For details regarding listening to the audio CD that you
have just created, refer to "Playing Back Audio CDs" (p.
224).
It may take a period of several seconds before the disc is
actually ejected.
• The range of available write speeds can sometimes
be limited by the type of media being used. In such a
case, the BR-1200CD will allow you to select only the
supported speeds.
• If an error occurs, try changing the write speed and
then carry out the writing process over again.
• The actual time required to complete writing to a
disc will be longer than the time calculated from the
write speed. The data is converted into CD format
during the writing process, and this accounts for the
extra time requirement.
Creating Audio CD
221