Boss MICRO BR Owner's Manual page 21

fig.eject-sd-j.eps
To remove the memory
card
Push it inward, and then release your
finger.
fig.sd-protect.eps
About the memory card write protect
function (Lock)
By moving the write protect switch located on the side of the
memory card to the "LOCK" position, you can make it impossible
for data to be written and erased to the card.
928
929
930
• We recommend that you use alkaline batteries.
• Don't mix new batteries with partially used batteries, and don't mix batteries of different types.
• When the icon
• The battery operating time will depend on the type of batteries and on the operating conditions. It will
also vary depending on the type and capacity of the SD memory card.
• Keep the included memory card out of reach of small children to prevent it from being swallowed
accidentally.
• For more about the memory cards (SD cards) recommended for use with the MICRO BR, refer to the
separate leaflet "About memory cards."
• Insert memory cards all the way into the slot, being careful to observe the correct direction and
orientation. Do not insert them forcibly.
• Don't touch the contacts of a memory card or allow them to become dirty.
• The power must be turned off when you insert or remove a memory card. Inserting or removing a
memory card while the power is on may damage the data on the card or render the memory card
unusable.
• When turning the unit upside-down, get a bunch of newspapers or magazines, and place them under the
four corners or at both ends to prevent damage to the buttons and controls. Also, you should try to orient
the unit so no buttons or controls get damaged.
• When turning the unit upside-down, handle with care to avoid dropping it, or allowing it to fall or tip
over.
1. Push 1. Push
appears, replace the batteries as soon as possible.
Getting ready to use the MICRO BR
2. Release your finger
Write
Protect
931
21