Rockford Fosgate RFX-8115 Operation & Installation page 23

Installing the Source Unit – Standard Mount
Antenna
CAUTION: Installation sleeve should be installed using the appropriate tabs
(refer to page 19)
• Install Source Unit by sliding unit into installation sleeve until it clicks into
place
• Mount Backstrap securely behind the instrument panel to prevent source
unit vibration
• Backstrap Screw should be 8mm max (use supplied screw)
• Connect Antenna to antenna jack on rear of source unit
• Antenna Ground should read less than 0.05
chassis ground
Installing the Source Unit – ISO Mount
Antenna
• Remove Trim Piece and Installation Sleeve from source unit
• Factory Bracket should align with two mounting holes on each side of
source unit
• ISO Screws should be 8mm max (use supplied screw)
• Connect Antenna to antenna jack on rear of source unit
• Antenna Ground should read less than 0.05
chassis ground
• Install Source Unit into instrument panel
• Replace Trim Piece on source unit if needed
8mm Max
Antenna Input
Antenna Input
– 20 –
Backstrap
Installation Sleeve
between antenna and
Factory Bracket
4mm Max
between antenna and
I
® ®
N
S
T
A
L
L
A
T
I
O
N
Trim Piece
Trim Piece