Table of Contents
Advertisement
11. Word Clock
11.1 Word Clock Input and Output
Input
The ADI-8 DS word clock input is active when WCK is chosen in the clock section. The signal at
the BNC input can be Single, Double or Quad Speed, the ADI-8 DS automatically adapts to it.
As soon as a valid signal is detected, the WCK LED is constantly lit, otherwise it is flashing.
Thanks to RME's Signal Adaptation Circuit, the word clock input still works correctly even with
heavily mis-shaped, dc-prone, too small or overshoot-prone signals. Thanks to automatic signal
centering, 300 mV (0.3 V) input level are sufficient in principle. An additional hysteresis reduces
sensitivity to 1.0 V, so that over- and undershoots and high frequency disturbances don't cause
a wrong trigger.
The word clock input is shipped as high impedance type (not terminated). A push switch allows
to activate internal termination (75 Ohms). The switch is found on the back beside the BNC
socket. Use a small pencil or similar and carefully push the blue switch so that it snaps into its
lock position and the yellow LED lights up. Another push will release it again and de-activate the
termination.
Output
The ADI-8 DS word clock output is constantly active, providing the current sample frequency as
word clock signal. In master mode, the word clock will be fixed to 44.1 kHz or 48 kHz (DS x 2,
QS x 4). In any other case the sample rate is identical to the one present at the currently cho-
sen clock input. When the current word clock source fails, the last valid sample rate will be held
automatically.
The word clock signal received by the ADI-8 DS can be distributed to other devices by using the
word clock output. Due to its efficient jitter reduction the ADI-8 DS can clean up any clock sig-
nal, refresh it, and provide it as reference clock at the BNC output. With this the usual T-adapter
can be avoided, and the ADI-8 DS operates as Signal Refresher. This kind of operation is highly
recommended, because
•
Input and output are phase-locked and in phase (0°) to each other
•
SteadyClock removes nearly all jitter from the input signal
•
the exceptional input (1 Vpp sensitivity instead of the usual 2.5 Vpp, dc cut, Signal Adapta-
tion Circuit) plus SteadyClock guarantee a secure function also with most critical word
clock signals.
Thanks to a low impedance, but short circuit proof output, the ADI-8 DS delivers 4 Vpp to 75
Ohms. For wrong termination with 2 x 75 Ohms (37.5 Ohms), there are still 3.3 Vpp at the out-
put.
22
User's Guide ADI-8 DS © RME
Advertisement
Table of Contents
