Table of Contents
Advertisement
The rear of the ADI-6432R BNC provides the following connections: 64 BNC connectors (AES-
3id I/O), two MADI optical, two MADI coaxial (BNC), two word clock (BNC), two MIDI (5-pin
DIN), one RS232 (D-Sub), and two mains power.
MADI I/O optical: Standard MADI ports.
MADI I/O koaxial (BNC): Standard MADI ports.
AES-3id (64 x BNC): Each of the 64 BNC sockets transfers 2 channels of digital audio each.
WORD IN (BNC): A push switch allows to activate internal termination (75 Ohms).
WORD OUT (BNC): Standard word clock output.
MIDI I/O (5 pin DIN): MIDI input and output via 5-pin DIN jacks. Used for transmission of MIDI
data via MADI, and for remote control of the ADI-6432.
COM (9 pin D-sub): Serial interface for data transmission via MADI.
IEC receptacle for power connection. The specially developed, internal hi-performance switch
mode power supply makes the ADI-6432 operate in the range of 100V to 240V AC. It is short-
circuit-proof, has an integrated line-filter, is fully regulated against voltage fluctuations, and sup-
presses mains interference.
The ADI-6432R BNC uses two identical, complete power supplies, which operate simultane-
ously and in parallel. This allows for a redundant operation on the power side by connecting the
second mains receptacle to a different power source. The unit will continue to operate without
interruption if one of the power sources fails.
8
User's Guide ADI-6432R BNC © RME
Advertisement
Table of Contents
