Ricoh DDP92 Installation Manual page 89

3) Cut off the coverings for the Cover Sheet Feeder fixtures from the Top cover.
(1) Cut off the Top auxiliary cover.
(2) Cut off the coverings for the Pre Sensor window.
[Note] Remove any remaining burrs after cutting off the parts.
Pre sensor
window
4) Install the accessories on the underside of the Top cover.
(1) Install two Pre-sensors. (Tapping screw M3x8:2)
(2) Secure the wires from the Pre-sensors with the Nylon clamps in three places. (Use
three 3N Nylon clamps and three M3x8 Tapping screws.)
Top auxiliary
cover
II L 00
Installation 4-46