Ricoh DDP92 Installation Manual page 68

15) Connect the CST AC cable coming from the Container Stacker to the J236 on the power
supply of the printer (Connection 1 on the below figure). At this time, connect CE AC cable
that is disconnected from the J236 to the connector of the CST AC cable (Connection 2 on
the below figure)
16) Mount the CST FG cable coming from Container Stacker side on the printer frame by using
M4 screw (Connection 3 on the below figure).
17) Install the CP P/K Holder and OC P/K ass'y in the Engine.
18) Connect FNS IF cable of 20 pin black connector coming from the printer to the J680
connector of ST09X P/K board in Container Stacker (Connection 4 on the below figure).
(Do not use the 4 pin white connector Disconnection 2 on the below figure).
19) Disconnect the 4 pin white connector of the DC IF cable of the printer from the FNS IF cable
(Disconnection 1 on the below figure). Then connect it to the RB cable of 4 pin white
connector coming from Container Stacker. (Connection 5 on the below figure)
[Note] Put the cable through the opening "A" of the Engine for connection.
CTS AC cable
Connection 1
Connection 2
CE AC cable
Details of Connection 1 and Connection2.
CE AC Cable
Connector : 2 pin white
J236
CST AC Cable
Connector : 2 pin white
PS
M4 screw
(Connection 3)
Engine
PS
CST FG cable
DC IF cable
II L
Installation 4-25
Opening "A"
FNS IF cable
RB cable
Connection 5
(4 pin white)
00
Disconnection 2
Container
(4 pin white)
Connection 4
(20 pin black)
Disconnection 3
(2 pin white)
PS
Disconnection 1
(4 pin white)