Flexfx Loop; Output Section; Headphone Cueing - Rane TTM 56 Operator's Manual

FlexFX Loop

FlexFX switches send PGM 1, PGM 2 or both to the stereo effects loop. The effects loop is post-fader and post-crossfader. You get
great results when using the program faders or crossfader with reverb or other delay effects. The effects loop provides separate
stereo send and return jacks. The green indicators light when FlexFX is engaged.
WET/DRY pan control lets you set the amount of effect in the mix. DRY equals no effect, WET gives maximum effect.

Output Section

MASTER control sets the level for both the unbalanced and balanced Master Outputs.
MIC
AUX OUTPUT control sets the level of the Auxiliary Outputs.
4
2

Headphone Cueing

0
LEVEL
The headphone amp in the TTM 56 has a high power output (unlike most you have used before). There
are notable differences...
• The headphone output of the TTM 56 delivers very high volume to your headphones.
-12
HIGH
• To avoid pain, never put headphones on your head before plugging them in.
• Always start with the PHONES LEVEL turned down, and then turn it up to the desired level.
• Because of the high current and low output impedance, never short one side to ground, or short left
-12
and right together as is possible with mono cup headphones.
LOW
• Low power headphone stages typically use large resistors on their outputs, which allow shorting, but
prevent high power. The TTM 56 gives you high power, but does not allow shorting.
4
2
MASTER / CUE switch is used to select the headphone monitor source:
0
AUX IN
• Use MASTER (out) to rehearse your performance. This signal is the same as the MASTER OUT,
but is not affected by the MASTER LEVEL control.
TTM 56
PERFORMANCE MIXER
• Use CUE (in) to monitor the Program Input signal before fading in. This signal is not affected by
the Program Faders or Crossfader. Because the Effects Loop is after the Fader, you will not hear effects
in the Cue.
CUE slider allows you to PAN between PGM 1 and PGM 2 in the headphones when the MASTER / CUE switch is depressed. When
the switch is released, this control has no effect.
PHONES LEVEL control sets the output level of the headphone amplifier.
FAST
CONTOUR
SLOW
HEADPHONES
PWR
PGM 1
6
8
10 OFF +6
OL HIGH
+12 OFF +6
MID
+12 OFF +6
LOW
6
8
L PAN R
10
REVERSE
TRANSFORM
MODE 1
MODE 2
A
PGM 2
4 6 4 6
2 8 2 8
0 10 0 10
GAIN GAIN
EQ EQ
FlexFX FlexFX
DRY WET
CHANNEL REVERSE
TRANSFORM
MONO PGM1 / PGM2
STEREO HOUSE
REVERSE MODE 1 MODE 2
B
4 6
2
OFF +6 0 10
HIGH MASTER
4 6
2
OFF +6 0 10
MID AUX OUT
4 6
2
OFF +6 0 10
LOW PHONES LEVEL
L PAN R MASTER / CUE
PGM 1 CUE
REVERSE
MODE 1
MODE 2
FAST
CONTOUR
SLOW
8
8
8
PGM 2
Manual-