Table of Contents
Advertisement
Volt Meter (BATT)
Tripmeter (TRIP)
Fuel Integration Meter
(TTL)
Fuel Economy Meter
(ECO)
Fuel Flow Meter (FLOW)
Water Separator Indicator
Shows the battery voltage . The engine cannot be started if the voltage is too low.
Shows mileage per trip on the water.
Display is reset by pressing and holding the Set and Mode switches at same time.
Indicates the total amount of fuel flow.
Display is reset by pressing and holding the Set and Mode switches at same time. The procedure
•
will only reset the outboard motor information currently displayed: S (starboard), P (port), or
S&P (starboard and port). If necessary, use the Set switch to select either S, P, or S&P (p.4) prior
to resetting the meter.
Display is indicated by a bar, not by figure, when the total amount of fuel flow is low such as at
•
idling or when trolling, and after resetting the meter or placing the meter into service for the first
time.
Shows the mileage per volume of fuel consumed on the water.
Display is indicated by a bar, not by figure, when the fuel consumed is low such as at idling or when
trolling.
Indicates the amount of fuel flow per hour.
Display is indicated by a bar, not by figure, when the fuel flow is low such as at idling or when
trolling.
The indicator blinks when water has accumulated in the water
separator. Only one outboard can be connected to the water
separator indicator. See your owner's manual for additional
information.
Normal
Abnormal
(No indication)
(Blinks)
5
Advertisement
Table of Contents
