Table of Contents
Advertisement
Tachometer
Hour Meter
Trim Meter
Oil Pressure Indicator
Overheating Indicator
Alternator (ACG) Indicator
Programmed Fuel Injection
(PGM-FI) Indicator
Shows the engine speed per minute.
Shows the total number of hours the engine has operated.
Total hours and trip hours are indicated alternately as the Mode switch is pressed.
Trip hour meter is reset by pressing and holding the Set and Mode switches at same time. Total
operating hours cannot be reset.
Shows the trim angle of the outboard motor. The figures shown on the sides of the bars are for
reference and are relative to the motor trim angle.
Memorize the trim angles that work best for your boat under different conditions. Adjust the trim
angle by operating the power trim/tilt switch.
• The uppermost bar will blink when the motor is trimmed beyond the maximum trim angle and
into the tilt angle range. Be sure to operate the outboard motor at proper trim angle.
*1
" " will be indicated when the oil pressure is normal while the engine is running. " " will disap-
pear if oil pressure becomes low. (Further, the engine speed will slow down gradually according to
the outboard motor's engine protection system. See your owner's manual for additional information.)
*2
" " will be indicated if there is any abnormality in the engine cooling system while the engine is
running. (Further, the engine speed will slow down gradually according to the outboard motor's
engine protection system. See your owner's manual for additional information.)
*3
" " will be indicated if there is any abnormality in the charging system while the engine is running.
*4
" " will be indicated if there is any abnormality in the PGM-FI System while the engine is running.
*1
Normal
Abnormal
*2
*3
*4
3
Advertisement
Table of Contents
