Table of Contents
Advertisement
Single Outboard Motor Operation
Speedometer
Fuel Level Meter
Volt Meter (BATT)
Tripmeter (TRIP)
Fuel Integration Meter (TTL)
Fuel Economy Meter (ECO)
Fuel Flow Meter (FLOW)
Water Separator Indicator
Shows the speed of the boat on the water.
Shows the amount of fuel left in the fuel tank of the boat.
The fuel reading can be affected by the position of the sensor in the fuel tank and the attitude of the boat
in the water. Operation with bow-up trim or continuous turning can give incorrect readings.
• When all block bars light, this indicates that the fuel tank is full. The lowermost block bar will blink
when the fuel level is low.
• The block bars will not light or blink when the digital speedometer's fuel meter is not used.
Shows the battery voltage. The engine cannot be started if the voltage too low.
Shows mileage per trip on the water.
Display is reset by pressing and holding the Set and Mode switches at same time.
Indicates the total amount of fuel flow.
• Display is reset by pressing and holding the Set and Mode switches at same time.
• Display is indicated by a bar, not by figure, when the total amount of fuel flow is low such as at idling
or when trolling, and after resetting the meter or placing the meter into service for the first time.
Shows the mileage per volume of fuel consumed on the water.
Display is indicated by a bar, not by figure, when the fuel consumed is low such as at idling or when
trolling.
Indicates the amount of fuel flow per hour.
Display is indicated by a bar, not by figure, when the fuel flow is low such as at idling or when trolling.
The indicator blinks when water has accumulated in the water
separator of the outboard motor. See your owner's manual for
additional information.
Normal
Abnormal
(No indication)
(Blinks)
3
Advertisement
Table of Contents
