Honda Pilot Owner's Manual page 233

SCAN The scan function samples
all stations with strong signals on the
selected band. To activate it, press
the SCAN button, then release it.
You will see SCAN in the display.
When the system finds a strong
signal, it will stop and play that
station for about 10 seconds.
If you do nothing, the system will
scan for the next strong station and
play it for 10 seconds. When it plays
a station that you want to listen to,
press the SCAN button again.
Playing the FM/AM Radio (EX and EX-L models)
Preset Each preset button can
store one frequency on AM and two
frequencies on FM.
1. Select the desired band, AM or
FM. You can store one frequency
on FM1, and one frequency on
FM2 with each preset button.
2. Use the tune, skip, scan, or RDS
function to tune the radio to a
desired station.
3. Pick a preset button, and hold it
until you hear a beep.
4. Repeat steps 1 through 3 to store a
total of six stations on AM and
twelve stations on FM.
2011 Pilot
On vehicles without rear entertainment
system
AUTO SELECT If you are
traveling and can no longer receive
your preset stations, you can use the
auto select feature to find stations in
the local area.
Press the A. SEL button. ''A. SEL''
flashes in the display, and the system
goes into scan mode for several
seconds. It stores the frequencies of
six AM and twelve FM stations in
the preset buttons.
You will see a ''0'' displayed after
pressing a preset button if auto
select cannot find a strong station for
that preset button.
If you do not like the stations auto
select has stored, you can store
other frequencies on the preset
buttons as previously described.
CONTINUED
229