Irregular Shaping - Grizzly G1035 Owner's Manual

2. Above the cutter:
Figure 48
Figure 48.
3. Between two cutters:
Figure 49.
Figure 49 .

Irregular Shaping

Freehand shaping greatly increases the
chance that the operator may lose control of
the workpiece, which could result in serious
personal injury. Therefore, a starting pin or
support MUST be used to start an irregular
shaping operation.
Rub Collars
When doing freehand work, a starting pin
must be used.
Figure 50.
Figure 50.
Figure 50.
ALWAYS FEED AGAINST THE ROTATION OF
THE CUTTER.
Page 32