Spindle
Incorrect assembly can allow the spindle
and cutter to fly off the machine, which
could cause injury or death. Make certain
the spindle is properly assembled before
operating the shaper. If you are uncertain of
any aspect of this assembly, please review
these instructions again or contact our
Technical Support.
To install a spindle:
1.
2.
Figure 16.
Figure 16 .
3.
17
Figure 17.
Make sure the spindle keyway and pin are
aligned and properly seated before tighten-
ing the drawbar nut. Improper assembly can
create an unsafe condition and possible
injury to the operator.
4.
Figure 18.
Figure
Figure 18 .