Advertisement
Table of Contents
For questions or help with this product contact Tech Support at (570) 546-9663 or techsupport@grizzly.com
Introduction
The T10667/T10668 Bald Eagle Floating Reamer
Holder Kit provides excellent accuracy and con-
trol when chambering gun barrels. The holder
compensates for a small amount of misalignment
between the chuck and tailstock, allowing the
reamer enough free movement to remain aligned
with the bore.
This type of holder permits the user to control the
reaming process and release the reamer from
action, preventing damage that can occur to a
barrel when reamers bind.
This reamer holder is only designed for use with
reamers that have properly fit bore bushings or
solid piloted reamers that have the pilot bushing
fitted to the bore. We recommend pre-boring the
chamber a little undersize and using a roughing
and/or a finishing reamer to complete the process.
Kit Specifications
T10667 Taper ............................................. MT#3
T10668 Taper ............................................. MT#4
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
COPYRIGHT © APRIl, 2013 BY GRIZZlY INDUSTRIAl, INC.
NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
#DM15699 PRINTED IN USA
MODEL T10667/T10668
BALD EAGLE FLOATING
REAMER HOLDER KIT
INSTRUCTIONS
Inventory
Description
A. Floating Reamer Holder ............................. 1
B. Round-Nose Dead Center .......................... 1
A
Figure 1. T10667 Bald Eagle Floating Reamer
Holder Kit.
Operation
This floating reamer holder is designed to comple-
ment a precise setup—not make up for an inac-
curate one. Before attempting to use the floating
reamer holder, it is critical that every component
used in your setup is adjusted as accurately
as possible. Additionally, alignment adjustments
should be indicated off the bore—not the outside
of the barrel.
Because a floating reamer is not rigidly restrained
like other methods of reamer control, it takes
experience through repetition to use it proficiently.
Before working with an expensive barrel, we
highly recommend practicing on a scrap barrel
until you are familiar with the feel and technique
of using a floating reamer.
Qty
B
Advertisement
Table of Contents
Related Manuals for Grizzly T10667
Summary of Contents for Grizzly T10667
- Page 1 MODEL T10667/T10668 BALD EAGLE FLOATING REAMER HOLDER KIT INSTRUCTIONS For questions or help with this product contact Tech Support at (570) 546-9663 or techsupport@grizzly.com Introduction Inventory Description The T10667/T10668 Bald Eagle Floating Reamer A. Floating Reamer Holder ......1 Holder Kit provides excellent accuracy and con- B.
- Page 2 To use the floating reamer holder when cham- Move the tailstock forward until the rounded bering a gun barrel: end of the dead center begins to enter the reamer holder (see Figure 3). Set up the barrel in your lathe, per your nor- mal method, centering the bore of the barrel as accurately as possible.
Need help?
Do you have a question about the T10667 and is the answer not in the manual?
Questions and answers