Advertisement
LINE CORD
Your amplifier is equipped with a grounding type supply
cord to reduce the possibility of shock due to electrical fault.
Be sure to connect it to a grounded receptacle. DO NOT
ALTER THE AC PLUG.
TUBES
The '63 VIBROVERB tube complement consists of two
Fender Special Design 6L6WGC/5881's (part number
039214), five Fender Special Design 12AX7A's (part num-
ber 013341), and one Fender Special Design 12AT7 (part
number 023531). Fender's Special Design Tubes provide
optimum performance in this amplifier. For best results,
replace with Fender original equipment tubes only. Tube
location is printed on the tube label, inside the cabinet.
TROUBLESHOOTER'S CHECKLIST
If the amp is set up but does not function, check the following items:
•
Is the amp power cord properly plugged into an electrical outlet?
•
Is there power at the outlet?
•
Is the fuse blown?
•
Are the speakers properly connected to the amplifier?
•
Is the amp on standby?
•
Is the amplifier volume control turned up above "three"?
•
Is the volume control on the instrument turned up?
•
Is your instrument properly plugged into the amplifier?
(Eliminate any effects pedals and try another guitar cord.)
If, after checking all of the above, the system is not performing
correctly, consult your Fender Service Center.
TOLEX COVERING CARE
The exclusive Fender Tolex covering on your cabinet is of
the same material that was used on the original
VIBROVERB. A very light soapy solution on a sponge may
be used to remove dirt and residue that may accumulate in
the grain. Be careful not to let liquid come in contact with
operating surfaces. DO NOT have the amplifier plugged
into a power outlet when cleaning.
Advertisement
