Table of Contents
Advertisement
Notes: You can also use the SURROUND button on the remote control to switch Virtual Surround on (V/TruSurround)/Off.
- Virtual Surround does not work with CD, MP3, DVD-Audio or SACD discs, or - The Virtual Surround effect is output only through
the 2 channel Analog Output
- Make sure that Audio Output Mode is set to 2 Channel.
- How good the surround effect is varies with the disc.
Channel Level
• Default setting: Fix
This setting allows you to set the level of each channel sent to the 6 channel analog outputs.
1 - Press HOME MENU and select 'Audio Settings' from the on-screen display.
2 - Highlight Channel Level, then use the cursor left/right to change to 'Fix' or 'Variable', as required.
• Fix – Channel levels are fixed
• Variable – You can specify variable channel levels as well as speaker distance
3 - If you chose Variable, press (cursor down) to proceed to the next screen.
4 - Variable setting only: Set the channel levels for each speaker.
• Use the cursor up/down to select a speaker.
• Use the cursor left/right to adjust the channel level for that speaker.
Channel levels can be set from –6 dB to +6 dB. in 0.5 dB increments.
5 - Press ENTER to make the settings and exit the audio settings screen.
Notes: You can't adjust the channel level for any speakers that are set to Off in the Speaker Installation menu screen.
- The Fix setting is equivalent to setting all the channel levels to +6 dB. Therefore, the Variable setting will usually sound quieter
than the Fix setting.
35
Advertisement
Table of Contents
