Table of Contents
Advertisement
- If you set to 2 Channel, Dolby Digital, DTS and MPEG audio is mixed down to two channels so you still hear all the audio recorded
on the disc.
- Some DVD-Audio discs don't allow down-mixing of audio. These discs always output multi-channel audio regardless of the setting
made here.
Speaker Installation
• Set in Setup Navigator (default: L/R: Large | C: Large | LS/RS: Large| SW: On )
You only need to make this setting if you connected this player to your amplifier using the 5.1 channel analog outputs.
This setting does not affect digital audio output.
Use the Speaker Installation screen to tell the player what kinds of speakers you have connected.
1 - Use the cursor up/down buttons to select a speaker
Note: The L and R, and RS and LS speakers are paired; you can't set them differently.
2 - Press (cursor right) to modify the selected speaker.
3 - Use the cursor up/down buttons to change the current setting.
Notes: You can see the effect of your changes in the room graphic on the right of the screen.
- Except for the subwoofer, you can set speaker size to Large or Small. If the main speaker cone in the speaker is 12cm or more,
set to Large, otherwise set to Small (or Off if you don't have that speaker).
- Setting the front L and R speakers to Small, automatically sets center and surround speakers are to Small and subwoofer to On.
- The subwoofer can only be set to On or Off.
4 - Press (cursor left) to go back to the speaker list if you want to modify another speaker, or press ENTER to exit the
Speaker Installation screen.
Speaker Distance
• Default setting: all speakers 3m
You only need to make this setting if you connected this player to your amplifier using the 6 channel analog outputs.
To get the best surround sound from your system, you should set up the speaker distances from your listening position.
1 Move the cursor up/down to select a speaker
- The L and R speakers are paired; you cannot set them differently
47
Advertisement
Table of Contents
