Advertisement
NOTE:
The short pointed bar is for mounting
on the bottom of the Epilogue 1. You
have to assemble it to the bottom of
the Epilogue 1.
4
ASSEMBLING
NOTE:
This is for users who will NOT use the Epiframe 1. The Epiframe 1 is an external structure holding an
Epilogue 2 and an Epilogue 1 together. This accessory is sold separately.
First put the speaker on its side on the floor. Use a soft cushion to avoid damaging it.
Screw the long pointed bar in the threading accessible in the speaker's bottom plate after
removing the big screw used for shipment. Tighten as much as you can.
Take the 2 transparent acrylic feet and assemble them to the back of the Epilogue 2 speaker,
each with 2 washers and screws. Do not over-tighten the screws to avoid cracking the acrylic.
Lift the Epilogue 2 speaker and put it on its feet. Adjust the leveling screw of each acrylic foot
to properly level each Epilogue 2 speaker.
You will now be ready to put the Epilogue 1 on top of the Epilogue 2.
Use the transparent acrylic small blocks to receive the back of the Epilogue 1.
The pointed bar assembled previously on the bottom of the Epilogue 1 must be set in the
gliding row engraved on the top silver plate of the Epilogue 2.
THE SPEAKER FEET
User Manual – GOLDMUND Epilogue 2 – 7
Advertisement
