Table of Contents
Advertisement
6) SATA2_0/1/2/3 (SATA 3Gb/s Connectors)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard.
Each SATA connector supports a single SATA device. The NVIDIA
ler supports RAID 0, RAID 1, RAID 5, RAID 10, and JBOD. Refer to Chapter 4, "Configuring SATA Hard
Drive(s)," for instructions on configuring a RAID array.
7) F_USB1/F_USB2/F_USB3 (USB Headers)
UG
The headers conform to USB 2.0/1.1 specification. Each USB header can provide two USB ports via an
T
optional USB bracket. For purchasing the optional USB bracket, please contact the local dealer.
• A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard
drives are to be used, the total number of hard drives must be an even number.
• A RAID 5 configuration requires at least three hard drives. (The total number of hard drives
does not have to be an even number.)
• A RAID 10 configuration requires four hard drives.
Prior to installing the USB bracket, be sure to turn off your computer and unplug the power cord
from the power outlet to prevent damage to the USB bracket.
GeForce 7025/nForce 630a control-
®
7
SATA2_3
1
SATA2_2
1
7
SATA2_1
1
7
SATA2_0
7
1
Please connect the L-shaped end of
the SATA cable to your SATA hard
drive.
Pin No. Definition
9
1
10
2
- 15 -
DEBUG
PORT
DEBUG
PORT
DEBUG
PORT
DEBUG
PORT
Pin No. Definition
1
GND
2
TXP
3
TXN
4
GND
5
RXN
6
RXP
7
GND
1
Power (5V)
2
Power (5V)
3
USB DX-
4
USB DY-
5
USB DX+
6
USB DY+
7
GND
8
GND
9
No Pin
10
NC
Hardware Installation
Hide quick links:
Advertisement
Table of Contents
