Gigabyte GA-M68M-S2P User Manual page 67

After that, the Array List screen appears, displaying the RAID array that you have created (Figure 7).
Boot
No
[Ctrl-X] Exit
To read more information about the RAID array, press <Enter> to enter the Array Detail screen (Figure 8),
which shows various information about the array, including the RAID mode, stripe block size, hard drive
model name, and hard drive capacity, etc.
RAID Mode: Striping
Striping Width : 2
[R] Rebuild
To delete the array, press <D> in the Array Detail screen. When the "Delete this array?" message appears,
press <Y> to confirm or <N> to cancel. Press <Enter> to return to the Array List screen.
To exit the NVIDIA RAID setup utility, press <Esc> in the main menu or <Ctrl>+<X> in the Array List screen.
Now, you can proceed to the installation of the SATA controller driver and operating system.
MediaShield Utility Nov 20 2006
Status Vender
Healthy NVIDIA
[ hi ] Select [B] Set Boot
MediaShield Utility Nov 20 2006
Port Index
1.0 0
1.1 1
[D] Delete
- Array List-
Array Model Name
STRIPE
[N] New Array [ENTER] Detail
Figure 7
- Array Details-
Striping Block: 64K
Disk Model
ST3120026AS
ST3120026AS
[C] Clear Disk
Figure 8
- 67 -
223.57G
Capacity
111.79GB
111.79GB
[ENTER] Return
Appendix