QSC Q-SYS I/O-22 User Manual page 14

I/O-22 Specifications
Controls and Indicators
Status LED
Power LED
ID button
Locate LED
Power Source
AUX PWR
PoE
Power Configuration
Single PoE
Dual PoE
1
Single PoE+
Dual PoE+
AUX PWR
Dual PoE or PoE and PoE+
1
Peak power, as measured over an approximately 10 second interval.
2
3 Numbers are typical output power.
Connectors
LAN Port A (Q-LAN Primary) PoE
LAN Port B (Q-LAN Redundant) PoE
Auxiliary functions (for future use)
Third-party control interface
Two GPIO Connectors
Line Out 1 and 2
Mic/Line In 1 and 2
Remote Display Connector
(for future use)
Loudspeaker Output
24 VDC Auxiliary Power Connector
Dimensions (HWD)
I/O-22 (without bracket)
I/O-22 (with bracket)
Weight
I/O-22 (without bracket)
Bracket
Green
Green
When pressed, the associated ID button in the Q-Sys Design flashes
Green Flashes when its associated ID button is pressed in the Q-Sys design
ROTE!: You must use either the AUX PWR or PoE. In addition, you can use both AUX PWR and PoE.
External Supply (not included), +24 VDC, 30 watts minimum, 1.25 A
PoE (IEEE 802.3.af) or PoE+ (IEEE 802.3at) via Q-LAN A, Q-LAN B or both.
Average Amplifier Power Output
2-3W @ 4Ω, 2-3W @ 8 Ω
8-10W @ 4Ω, 4W @ 8 Ω
8-10W @ 4Ω, 4W @ 8 Ω
8-10W @ 4Ω, 4W @ 8 Ω
8-10W @ 4Ω, 4W @ 8 Ω
RJ-45
RJ-45
USB 2.0 host port interfaces (type A)
RS-232
6-Pin Euro-Style connector
3-Pin Euro-Style connector
3-Pin Euro-Style connector
RJ-45
2-Pin Euro-Style connector
2-Pin Female Euro-Style connector
1.74" x 9.10" x 6.20" (45.0 mm x 231.0 mm x 157.5 mm)
1.97" x 9.10" x 6.20" (50.0 mm x 231.0 mm x 157.5 mm)
3.0 lbs (1.4 kg)
0.5 lbs (0.2 kg)
14
Peak Amplifier Power Output
3
9W @ 4Ω, 4W @ 8Ω
9W @ 4Ω, 4W @ 8Ω
9W @ 4Ω, 4W @ 8Ω
9W @ 4Ω, 4W @ 8Ω
9W @ 4Ω, 4W @ 8Ω
2, 3