Creating A Data Migration Job Group In The Cli; Using The Data Migration Wizard; Starting The Data Migration Wizard - Qlogic Data Migration Service User Manual

Creating a Data Migration Job Group in the CLI

The data migration group name must be a minimum of 4 and a maximum of 128
alphanumeric characters. You can create a maximum of eight job groups in
addition to the default job group.
To create a data migration job group in the CLI:
1. Log in to the MPX200 as guest and enter the password.
2. Open a miguser session using the following command:
miguser start -p migration
(The default password for misguser is migration.)
3. Create a migration group using the following command:
migration_group add
4. At the prompt, enter a name for the new group.
The following shows an example of how to add a migration group in the CLI.
MPX200 (miguser) #> migration_group add
Please Enter Group Name that you want to create (Min = 4 Max = 128
characters) MS_Exchg_2
Sucessfully created Group

Using the Data Migration Wizard

The Data Migration wizard helps simplify the configuration and scheduling of both
individual and batches of data migration jobs. This section contains the following
information for the wizard:
"Starting the Data Migration Wizard" on page 3-7
"Scheduling an Individual Data Migration Job in the GUI" on page 3-8
"Scheduling an Individual Data Migration Job in the CLI" on page 3-11
"Scheduling Data Migration Jobs in Batch Mode" on page 3-15

Starting the Data Migration Wizard

Follow these steps to start the data migration wizard.
ISR654606-00 A
MS_Exchg_2
3–Using DMS
Using the Data Migration Wizard
3-7