Restoring A Switch - Qlogic SANbox 5600 Series User Manual

4 – Managing Switches

Restoring a Switch

Restoring a Switch
Restoring a switch loads the archived switch configuration parameters to the
switch. The administrative state of the switch must be set to "offline" using the
Switch Properties dialog before an archive can be used in the restore process.
The switch archive must be compatible with the switch to be restored; that is, you
can not restore a SANbox 5600 Series switch with an archive from a SANbox
9000 Series switch. Refer to
information.
CAUTION!
To restore a switch, do the following:
1. Log in to the fabric through the switch you want to restore. You cannot
restore a switch over an ISL.
2. Open the Switch menu and select Restore to display the Restore dialog
(Figure
Restore tab.
Figure 4-14 Restore Dialogs – Full and Selective
4-34
"Archiving a Switch" on page 4-33
The switch being restored should be physically disconnected from
the fabric. Restoring a switch in a fabric can severely disrupt the
fabric. After the restore process is complete, the switch can be
reconnected to the fabric.
4-14). The Restore dialog offers a Full Restore and a Selective
S
for more
59235-03 A