Powering Down The Dvr - Q-See QSD42908 Net User Manual

15 Reserved
16 F1
17 Lens control
18 F2
Loading the batteries into the IR controller
1. Remove the battery cover.
2. Insert the battery. Make sure that the poles (+ and -) are correctly positioned.
3. Replace the battery cover.
Starting the Remote Control
Press【DEV】key, input the DVR device ID (default is "88", can be changed in
"Display" menu) and then press the 【ENTER】 key. If the "STATUS" light of the DVR
front panel is green, it means you can use the remote control to operate the DVR.
Disabling the Remote Control
When the remote control status is on, press【DEV】key again, the "STATUS"
light will turn off. Then the remote control can not control the DVR.

Powering Down the DVR

When the remote control status is on, press【POWER】key for several seconds,
the DVR will be powered off.
If Remote Control Does Not Work
l Check pole positions of batteries.
l Check the remaining charge in the batteries.
l Check to see if the sensor is blocked.
l If the problem still exists, please contact Administrator.
QSD42908 User's Manual
Same as【F1】key of front panel.
IRIS, FOCUS ZOOM for lens
control.
Same as【F2】key of front panel.
12