Advertisement
Set up your remote control to operate other brand name devices
Turn on the device you want to program.
On the chart on page 46/47, find the typeof device you're
programming, and then find the brand name. Make a note of
thethree-number code, you'll needitsoon.
Pressand ho[tdPRG.It's recessedso it doesn'tget pushed
accidental.ly. Usea smaU., b [tunt object. When the indicator
light turns on, you can releasePRG.
Push the key name with the type of device you're program-
ming (MCR, C ABLE, A UX,TV).
Using the NUMBER keypad, enter the three-number codeyou
found on page 46/47.
Press ENTER to save the code. (The indicator [tight wi[tl flash
3 times, then turn off to indicate the code is valid.)
Point theremoteatthedevice and pushPOWER. Itshould
turnoff. Ifnot, trytheother codes[listed
and continue f rom
stepthree.
Note: To reset r emoteto factory settings,
enter 9-1-1, in
Step5.
Note: After programming, b e sureto press themode key
first to operate t hedevice you havejustprogrammed.
Programming yourZenith remote may allowyou to use one remote
to work up to 7 different devices.
Not all devices will work with y()ur Zenith remote control.
PROGRAMMING
Procedure to setup remote tooperate other equipment.
PRG
Programming mode ke_/.
DEVICE
Infra-red
remotecontro[tlab[e
electronic
accessory equipment.
2o_
PAGE
43
Advertisement
