Zenith INTEQ SRX3253 Operating Manual & Warranty page 89

What you should do when you get a
new 1/CR
NOTE: THIS PROCEDURE REQUIRES THE USE
OF THE UNIVERSAL REMOTE.
Make sure your Remote Emitter is positioned 2-3 inches in
front of your new VCR. Find the code(s) for your brand of
new VCR on the "VCR Code" chart and write the code(s)
here.
l, Press TO DO until you see the StarSight Setup menu.
2, Press the ,l, to highlight "Change VCR."
SeLect 6uideoChannels J
Change Channel Order
Change Cable Box/Service
Change VCR
Re-Activate/Change Address
StarSight Demonstration
Use
**
then STAR to choose
To exit, press. QUIT
_]_ CNN CBL _ 5:02P
3. Press STAR and follow the on-screen instructions.
I
YOU SHOULD ALSO KNOW...
• It is important that your equipment works properly
during each test. For example, make sure your VCR
turns on. If the equipment does not respond, you
need to try another VCR code and test your VCR
acain.
• Remember to reprogram your remote so it can
operate your new VCR. See the section on
"Universal Remote Control" in the TV portion of
this guide.
• If you have tried all the codes and need assistance,
call the StarSight Help Desk at (800) 628-STAR.
Select Guide Channels
Change Channel Order
Change Cable Box/Service
Change VCR
j
Re-Activate/Change A'ddres's
StarSight Demonstration
Use
**
then STAR to choose
To exit, press QUIT
CNN CBL [_ 5:02P
What changes are you making
to your VCR?
1. Add VCR
2. RepLace VCR
2. Remove VCR
Enter your selection here:
To continue, press ENTER.
To exit, press QUIT.
21x_.2'_4,_-o_-A D-- l