Connections With A Cable Box - Zenith VRC4165 Operating Manual And Warranty

..-v
INSTALLATION/Step A
Connections
VCR
Back Panel
VIDEO
L-AUDIO-R
®ouT®
OUTTO "IV
ote: The VCR Antenr_ Connections provide
"loop-through for the incoming signal for
ewing the TV while the,.VCR is either Off or
m Timer Recording mode, the Audio/Video con-
Standard I
n,_=,r_o_=,, taections do not. Be sure to make the Antenna
An_mn="ryp_
f-
_onnections as describe, d here (in addLition to the
__aseband Audio/Video connections if you
or
_hoose that option) to be able to view the TV
_ _vhile the VCR is either Off or in Timer mode.
CH3 CH4
Note: Make sure connector pins
fits inside jack center holes.
(_ I1_ BT_aP/C_laneTVi
Step 1. Connect your antenna type or CATV cable to VCR ANT IN.
Step 2. Connect Hook-up Cable from VCR OUT TO TV to TV Ant In.
Step 3. Set CH3-4 Switch on VCR back panel to CH3.
Connections with a Cable Box
Cable/Converter Box
j Back Panel
I_TLE C_L_.
Typi,:al TV
Back: Panel
Step 1. Commct CATV Cable to Cable In.
Step 2. Cormect Cable Out to VCR IN FROM ANT.
Step 3. Comlect Hook-up Cable from VCR OUT TO TV to TV Ant In.
Step 4. Set (7H3-4 Switch on VCR back panel to CH3.
_,-o 1 _ 2