Important Safety Instructions - Electrolux SWS1233CS0 Owner's Manual

Important Safety
Instructions
(continued)
Avoid fire hazard or
electrical shock. Do not use an
adaptor plug or extension cord or
remove grounding prong from
electrical power cord. Failure to
follow this warning can cause
serious injury, fire or death.
Grounding type
wall receptacle
Do_ot under _1
or bypass
the grom_ding prong
this plug,
grounding plug
CORRECT
Use this way ONLY
Do not use or mix
liquid chlorine bleach with other
household chemicals such as toilet
cleaners, rust removers, acid or
products containing ammonia.
These mixtures can produce
dangerous fumes which can cause
serious injury or death.
Prevent Injury
To prevent shock hazard and assure stability during operation, the
washer must be installed and electrically grounded by a qualified service person in
accordance with local codes. Installation instructions are packed in the washer for
installer's reference. Refer to INSTALLATIONINSTRUCTIONSfor detailed grounding
procedures. If the washer is moved to a new location, have it checked and
reinstalled by a qualified service person.
To prevent personal injury or damage to the washer, the electrical
power cord of the washer must be plugged into a properly grounded and polarized
3-prong outlet. The third grounding prong must never be removed. Never
ground the washer to a gas pipe. Do not use a n extension cord or an adaptor
plug.
Follow package directions when using laundry products. Incorrect
usage can produce poisonous gas--resulting in serious injury or death.
• Do not combine laundry products for use in 1 load unless specified on the
label.
• Do not mix chlorine bleach with ammonia or acids such as vinegar.
To prevent serious personal injury and damage to the washer:
• All repairs and servicing must be performed by an authorized servicer
unless specifically recommended in this Owner's Guide. Use only authorized
factory parts.
• Do not tamper with controls.
• Do not install or store the washer where it will be exposed to the weather.
ALWAYS disconnect the washer from the electrical supply before
attempting any service or cleaning. Failure to do so can result in electrical shock or
injury.
To prevent injury, do not reach into the washer while parts are
moving. Before loading, unloading or adding items, push in the cycle selector knob
and allow the tub to coast to a complete stop before reaching inside.
[] Failure to comply with these warnings could result in serious personal injuries.
[] This washer is equipped with an electrical overload protector. The motor will
stop if it becomes overheated. The washer will automatically restart after a cool
down period of up to 30 minutes, if the washer has not been manually turned off
during this time.
SAVE THESE INSTRUCTIONS
Note: The instructions appearing in
this Owner's Guide are not meant to
cover every possible condition and
situation that may occur. Common
sense and caution must be practiced
when installing, operating and
maintaining any appliance.