Foxconn 945P7AA series User Manual page 27

IrDA Connector: IR (Refer to Item 21 on motherboard layout in Chapter 1 for
detailed location)
This connector supports wireless transmitting and re-
ceiving device. Before using this function, configure the
settings of IR Mode from the "Integrated Peripherals"
section of the CMOS Setup.
1394 Connector (optional) : F_1394 Refer to Item 7 on motherboard layout in
Chapter 1 for detailed location)
The 1394 expansion cable can be connected to either
the front (provided that the front panel of your chassis
is equipped with the appropriate interface) or rear
panel of the chassis.
S-ATA Connectors
11 on motherboard layout in Chapter 1 for detailed location)
The S-ATA connector is used to connect the S-ATA de-
vice to the motherboard. These connectors support the
thin Serial ATA cables for primary internal storage
devices. The current Serial ATA interface allows up to
150MB/s data transfer rate.
SP
layout in Chapter 1 for detailed location)
The out connector is capable of providing digital
audio to external speak-ers or compressed AC3 data to
an external Dolby digital decoder.
Note: The empty pin of SPDIF cable should be aligned
to empty pin of S/PDIF out connector.
20
Chapter 2
: SATA_1, SATA_2, SATA_3, SATA_4 (Refer to Item
(optional)
Installation Instructions
1
IR
10
GND
+12V
TPB -
TPA -
F_1394
GND
1
T X +
SATA _1/SATA _2/
SATA _3/SATA _4
(Refer to Item 1 on motherboard
Empty
SPDIF_OUT
GND
SPDIF_OUT
IRTX
GND
IRRX
Empty
+5V
9
Empty
+12V
TPB +
GND
TPA +
2 1
RX-
TX-
GND
RX+
GND
+5V