Cleaning After Soldering; Guard Crossing Test Waveforms - Fluke 8842A Instruction Manual

6-78. Cleaning After Soldering

T.M.C. Cleaner and similar products can can attack the nylon
latches and other plastic pieces.
If a PCA has been soldered, it should first be cleaned with SPRAYON T.M.C Cleaner
(rosin flux remover) or equivalent. The PCA should then be cleaned with water as
described above.
CAUTION
Figure 6-21. Guard Crossing Test Waveforms
Maintenance
INTERNAL CLEANING
f6-21.wmf
6
6-71