Table of Contents
Advertisement
To make the male inlay piece I've installed the 20 mm ring, leaving the 10 mm bit in. To cut out the
inlay, the router's depth is set to cut all the way through the 5 mm stock. In this picture, the red arrow
indicates the router's path, only traveling around the template's perimeter.
Here is the piece cut free. Unlike the female piece the male has square corners.
© 2008-2009, Brice Burrell
Page 34
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the MFS Multi-Routing Template System and is the answer not in the manual?
Questions and answers