Fantasea EyeDaptor FXF80 Instruction Manual

Fantasea EyeDaptor FXF80/100/200-F67
The EyeDaptor FXF80/100/200-F67 enables mounting accessory
lenses and filters with a 67mm thread mount on the FujiFilm WP-
FXF80, WP-FXF100 and WP-FXF200 housings.
Mounting Lens Accessories with a 67mm Thread Mount on the
FujiFilm WP-FXF80/100/200 Housing
1. Please use the utmost care and do not use excessive force when assembling and
disassembling the different lens accessories, in order not to cause any damage to
the products.
2. Attach the secure line to the adaptor and the housing, in order to secure the lens
and adaptor to the housing.
3. Install the EyeDaptor FXF80/100/200-F67 by attaching it to the housing lens port.
Prior to installing the adaptor, make sure you are holding it according to the shape
of the lens port, so the gap designed on the lens adaptor corresponds with the
housing built-in flash diffuser (image A). To install the adaptor, push it against the
lens port starting from the bottom right corner (when facing the housing) and
proceeding towards the top left corner, where the housing built-in flash diffuser is
located. After adaptor installation, make sure it is properly attached by gently trying
to pull it out. If properly installed, the adaptor should not easily come off the lens
port.
(Cat. No. 4706)
Instruction Manual
Image A
EyeDaptor FXF80/100/200-F67 Instruction Manual