Fantasea EyeGrabber FP7000 Instruction Manual

The EyeGrabber FP7000 allows for secure storage of Fantasea accessory lenses and filters when not installed on the
housing.
Compatible with the Following Lens Accessories:

BigEye Lens FP7000 (Cat. No. 5136)

EyeDaptor FP7000-F67 (Cat. No. 4702) - with any lens mounted on top of the adaptor

EyeDaptor S90/S95-F67 (Cat. No. 4710) - with any lens accessory mounted on top of the adaptor

RedEye Filter FP7000 (Cat. No. 5211)

PinkEye Filter FP7000 (Cat. No. 5212)

SharpEye Lens M67 (Cat. No. 5128) - only when mounted on top of the EyeDaptor FP7000-F67 (Cat. No.
4702)

Any of the lens accessories mentioned above can still be mounted on the EyeGrabber when color correction
inserts are installed inside
Included in the Kit:
EyeGrabber FP7000
Instructions for Use:
1. Assembling the EyeGrabber Lens Holder on a Flex or Ball & Joint Arm
a. Please use the utmost care and do not use excessive force when assembling and disassembling the different
accessories, in order to not cause any damage to the products.
b. It is advisable to mount the EyeGrabber on the arm prior to installing the arm on the housing tray or handle.
c. Remove the screws from the T2 Connector so that the two parts of the T2 Connector are disconnected. Please
note that there are two sets of screws included in the kit. The type of screws compatible with your arm
depends on the model of the arm. In general, longer screws are compatible with wider arms, such as Fantasea
Flex arms, while shorter screws are compatible with narrower arms, such as Ball & Joint arms. Choose the
proper set of screws for your system and leave the screws installed only inside the front part of the T2
Connector (image #1 on the following page). Keep the other set of screws in storage for future use, in case you
replace the arms used in your system.
Fantasea EyeGrabber FP7000
(Cat. No. 4057)
Instruction Manual
T2 Connector
EyeGrabber FP7000 Instruction Manual 20110523
Set of 2 shorter screws