Advertisement
Follow these steps if you sprayed oil-based
materials,
or if you sprayed latex materials
and do not have a garden hose available.
Be sure to use the appropriate
cleaning
solution for the type of material
sprayed.
Youwill need:
• Mineral spirits if using oil-based material
• Warm, soapy water if using latex material
• Waste container
1. Perform Pressure Relief Procedure
(page 7).
2.
Remove the spray tip and
place into an empty waste
container.
3. Submerge suction set into a bucket
with the appropriate cleaning
solution.
4. Point the spray gun at the side of
5.
a waste container.
Ground the
gun against the side of a metal
waste container
if flushing
with
mineral spirits.
While squeezing the trigger, turn the power
ON, and turn the PRIME/SPRAY knob to
SPRAY - MINIMUM PRESSURE.
6.
Continue squeezing the trigger
until fluid is coming out clear.
You may need to get new
cleaning solution.
7. Perform Pressure Relief
Procedure, page 7.
If you flushed the sprayer with
mineral spirits
repeat the steps on
this page using warm, soapy water.
18
Advertisement
