Advertisement
Youwill need:
• A water source that can be delivered with
a garden hose (latex materials only)
• Mineral spirits if using oil-based material
• Empty waste container
• A container with warm, soapy water
Cleaningnotes- read before cleaning
• When using latex material, clean sprayer and components with warm, soapy water. For oil based material use mineral
spirits. Never use mineral spirits with latex materials
• NEVER use gasoline to clean sprayer
• Dispose of used cleaning solution properly
• Thorough cleaning and lubrication of sprayer is important to ensure proper operation after storage
• If you flush your sprayer with mineral spirits, repeat Cleanup_ instructions using warm, soapy water.
Follow these steps whenever cleaning with mineral spirits:
• If spraying or cleaning with oil-based materials, the spray gun must be grounded while preparing the spray hose or
cleaning.
• Ground the gun by holding it against the edge of a metal container while purging.
Failure to do so may lead to a static
electric discharge which may cause a fire.
• Always flush spray gun at least one hose length from spray pump.
• If collecting flushed solvent in one gallon metal container, place it into an empty five gallon container, then flush.
• Area must be free from vapors.
• Follow all cleanup instructions.
Cleanup- Latex materials
Follow these steps if you used latex materials
and if you have a garden hose available,
if you do not
have a garden hose available,
follow
the Cleanup - Oil-Based
Materials instructions on page 18.
I
1. Perform Pressure Relief Procedure
(page 7).
2.
Remove the spray tip and
place into container filled
with warm, soapy water.
3. Place the suction tube and return tube
into an empty waste container.
4. Using a garden hose, rinse off the
suction tube, return tube and inlet filter.
Empty the waste container of all fluids.
16
Advertisement
