Adjusting The Cutting Height - Exmark LAZER Z CT Operator's Manual

Operation
3. To move forward in a straight line apply equal
forward pressure to both levers.
To turn left or right, pull the motion control lever
back toward neutral in the direction desired.
The machine will move faster the farther the
motion control levers are moved away from
neutral.
4. To stop, pull the motion control levers back to
the neutral position.
Figure 7
1. Handles Out (Neutral
Lock)
2. Handles In (Neutral)
3. Front of Unit
Driving in Reverse
1. Move the motion control levers inward to the
center to the neutral unlocked position.
2. To move rearward in a straight line applying equal
pressure pull both motion control levers rearward.
To turn left or right, release pressure on the
motion control lever toward the direction desired.
3. To stop, push the motion control levers to the
neutral position.
4. Forward
5. Reverse

Adjusting the Cutting Height

The cutting height of the mower deck is adjusted
from 1 1/2 to 4 1/2 inches (3.8 cm to 11.4 cm) in
1/4 inch (6.4 mm) increments.
1. Stop the machine and move the motion control
levers outward to the neutral locked position.
2. Disengage the PTO.
3. Raise the deck height lever to the transport
position (also the 4 1/2 inch (11.4 cm) cutting
height position)(Figure 8).
The deck can be raised by pulling the deck lever
up and/or by pushing down on the foot operated
deck lift assist lever located at the front right
corner of the floor pan.
Note: When changing the cutting height
positions, always come to a complete stop
and disengage the PTO.
1. Lever in transport and 4 1/2 inch (11.4 cm) cutting
height position
4. Insert the height adjustment pin into the hole
corresponding to the desired cutting height and
install the hairpin cotter pin.
See the decal on the side of the deck lift plate for
cut heights.
5. Move the deck height lever out of the transport
position (or 4 1/2 inch (11.4 cm) cutting height)
and down onto the height adjustment pin to mow
at selected height.
Note: The foot operated deck lift assist lever
can be used to momentarily lift the deck to clear
objects. Be sure that PTO is disengaged.
22
Figure 8