Download Print this page

Troy-Bilt 24B-060F063 Operator's Manual page 13

Chipper/shredder/vacuum/hose

Advertisement

SECTION 6: TROUBLESHOOTING
Problem
Engine fails to start
Engine
runs erratic
Too much vibration
Engine overheats
Occasional skip (hesitates
at high speed
Unit does not discharge
Cause
1.
Spark plug wire disconnected.
2.
Fuel tank empty or stale fuel.
3.
Throttle control lever not in correct
starting position. (If Equipped)
4.
Choke not in CHOKE position.
5.
Blocked fuel line.
6.
Faulty spark plug.
1.
Spark plug wire loose.
2.
Unit running on CHOKE.
3.
Blocked fuel line or stale fuel.
4.
Water or dirt in fuel system.
5.
Dirty air cleaner.
6.
Carburetor out of adjustment.
1.
Loose parts or damaged impeller.
1.
Engine oil level low.
2.
Dirty air cleaner.
3.
Carburetor not adjusted properly.
1.
Spark plug gap too close.
1.
Discharge chute clogged.
2.
3.
Lowengine
RPM
4.
Vacuum bag is full.
1.
Low engine RPM.
2.
Chipper blade dull.
Foreign object lodged in impeller.
Rate of discharge slows
considerably or
composition of discharged
material changes.
NOTE: For repairs beyond the minor adjustments listed above, contacl
Remedy
1.
Connect wire to spark plug.
2.
Fill tank with clean, fresh gasoline.
3.
Move throttle lever to FAST position.
4.
Move choke to CHOKE position.
5.
Clean fuel line.
6.
Clean, adjust gap, or replace.
1.
Connect and tighten spark plug wire.
2.
Move choke lever (if equipped) to OFF
position.
3.
Clean fuel line; fill tank with clean, fresh
gasoline
4.
Drain fuel tank. Refill with fresh fuel.
5.
Clean or replace air cleaner.
6.
See authorized service dealer.
1.
See authorized service dealer.
1.
Fill crankcase with proper oil.
2.
Clean or replace air cleaner.
3.
See authorized service dealer.
1.
Adjust gap to .030".
1.
Stop engine immediately and
disconnect spark plug wire. Clean flail
screen and inside of discharge opening
2.
Stop engine and disconnect spark plug
wire. Remove lodged object.
3.
Always run engine at full throttle.
4.
Empty bag.
1.
Always run engine at full throttle.
2.
Replace chipper blade or see your
authorized service dealer.
zour nearest authorized service dealer.
13

Advertisement

loading

This manual is also suitable for:

24c-060f06324a-060f063