Table of Contents
Advertisement
Configuring the antennainput
sourcefor the ANT/CABLE t erminal
1
From
the SETUP
menu,
highlight
ANT/CABLE
In.
• Programming channels when the ANT/CABLE input is
configured for Cable will take substantially
longer than
when the antenna input is configured
for Antenna.
This
is normal; however, once channel programming
is
finished, you should not have to repeat the programming
process again unless your Cable TV service lineup
changes significantly.
1
Configure
the ANT/CABLE
input,
if you
have
not already
done
so (_
left-hand
column).
2
From
the SETUP
menu,
highlight
Auto
Tuning.
3
A screen
will appear
warning
that
previous
programs
and settings
will be deleted.
2
Press
< or b" to select
the input
source
(Antenna
or Cable)
for the ANT/CABLE
input
on the TV
and press
FE-_.
Programming channelsinto the
TV's channel memory
When
you press
_
or _," on the remote
control
or TV
control
panel,
your
TV wily sto_p only on the channels
you
programmed
into the TV s channel
memory.
Follow
the steps
below
to program
channels
into the
TV's channel
memory.
Auto Tuning
Your
TV can automatically
detect
all active
channels
in your
area and store
them in its memory.
After the
channels
areprogrammed
automatically,
you can
manually
addor
erase
individual
channels
in the
channel
memory.
Note:
• You must configure the ANT/CABLE input source before
programming
channels.
• If the ANT/CABLE input is configured for Cable, the
automatic channel programming
process erases
channels that were previously programmed
into the TV's
memory.
• If the ANT/CABLE input is configured forAntenna,
the
automatic channel programming
process adds newly
found channels to the existing set of programmed
channels (and does NOT erase channels that were
previously programmed
into the TV's memory.) To
remove an Antenna source channel from the memory,
you must set it to Skip.
• To tune the TV to a channel not programmed
in the
channel memory, you must use the Channel Number
buttons on the remote control.
4
Press
_
to start
Auto
Tuning.
The TV will automatically
cycle through
all the
channels,
and
store
all active
channels
in the
channel
memory.
When
Auto Tuning
is finished,
press
(_ or _," to view
the programmed
channels.
Manual Tuning
After
automatically
programming
channels
into the
channel
memory,
you can manually
enter channels
if
the physical
channel
is known.
1
From
the SETUP
menu,
highlight
Manual
Tuning
and press
_.
2
Use the Channel
Numbers
on the remote
control
to enter
the channel
number
(up to three-digit
number)
and press
_.
If channels
are found,
they
will be listed
at the
bottom
of the screen.
Analog
channels
will be noted
by an ' ATV
symbol,
digital
channels
by a "DTV"
symbol.
37
Hide quick links:
Advertisement
Table of Contents
