EVGA nForce 3 250 User Manual page 47

This item is used to select the VDIMM voltage. If the VDIMM Over
Voltage is enabled, the options for this selection are 2.55V,
2.65V(Default), 2.75V or 2.85V. If the previous option is disabled, the
settings are 2.50V, 2.60V(Default), 2.70V and 2.8V.
VDDQ Select
This item is used to select the VDDQ voltage. If the VDDQ Over Voltage
is enabled, the options for this selection are 1.55V(Default), 1.65V,
1.75V or 1.85V. If the previous option is disabled, the settings are
1.50V(Default), 1.60V, 1.70V and 1.80V.
Vcore Over Voltage
This item is used to set the Vcore Voltage for the processor. The
selections for this item are Disabled, +50mV, +100mV and +150mV.
Hammer FID Select
The configuration settings for this option are Default (Recommended),
X4 800MHz – X12 2400MHz in 200MHz increments.
Hammer Vcore Select
The configuration settings for this option are Default (Recommended),
1.550V – 0.825V in 25V increments.
47