2.3.2. Communication Protocol Setting
st
nd
rd
The 1
, 2
and 3
protocol is EVF.
Notice: Please make sure the power is off before setting, and restart the
EPTZ3600/EPTZ3600I to enable a new value after changing.
Set all of protocol switches to ON; the speed dome EPTZ3600/EPTZ3600I will
enter a self-test mode.
2.3.3. Transmission Speed Setting (Baud Rate Setting)
th
th
The 4
and 5
bits on the PCB board are used to set the Baud Rate. The default baud rate
setting is 9600.
SW2
Protocol
Baud Rate
Terminal
Resistance
Notice: Please make sure the power is off before setting, and restart the
EPTZ3600/EPTZ3600I to enable a new value after changing.
bits are used to set communication protocol. The factory default
9600 BPS
4800 BPS
20
2400 BPS
1200 BPS