Connecting an audio system
This connection
allows you to use an audio amplifier
to adjust the
audio level. This also allows you to use external speakers.
To control
the audio, turn on the TV and the stereo amplifier,
and
turn off the built-in
speakers
(see "Turning
off the built-in
speakers"
on page 56).
You will need:
• one pair of audio cables
Note:
To/?earsound when using an external audio amplifier,
the volume of both the TVand the amplifier must be
set above 0 (zero)
Connecting an A/V receiver
This connection allows you to use an A/V (audio/video) receiver to
enhance your TV's sound.
If you have a system with Dolby Pro Logic c_surround sound, you can
add to the realism of the sound by using the TV's internal speakers as
center channel speakers.
You will need:
• one set of standard A/V cables
• one single audio cable for the audio center channel
I
Video
OUT
To A/V receiver
I
I
TV
Center
IN
OUT
_+_'_&_
I ON _
OFF
TV
Note:
Refer to the instructionsprovided withyour A/V receiver
for detaffsabout your surround sound system
When the Audio Center Channel ON/OFF switchis in
the ON position, the TVspeakersw#l function only as
center channel speakers
Adjust the volume for the center channel speakers
using the center level control on the A/V receiver
Touse the TVspeakersas normal speakers,set the
Au&o Center Channel ON/OFF swigchto the OFF
pos]don
@@
<o/<o/
+°'_® ® [_ :+ ,,=' I _'i'
!_@ @
r@' @ ll_r+@i
L+ ®
@
_ IKO+?@I
+,_+,+o_o+
o:
Caution:
Toavoid damaging the speakers
• TumofftheTVoffbeforecenneetingor
discenneeOngthe Audio Center Channel
cable
• DonogeonnectfmmtheA/Vreeeiver's
Center Speaker OUT (amplified signal) to
the TV'sAudio Center Channel IN_
Dolby Pro Logic* surround sound
system connection example
Audio
Video
TV
_eft
_
_Right
_peaker
_
_
_
speake
Surround
_
Surround
speaker
L
jZ_h
speaker
R
* Dolby Pro Logic is a registered trademark
of Dolby Laboratories Licensing
Corporation.