Sony Handycam DCR-DVD200 Operating Instructions Manual page 95

Connecting your camcorder to your computer - Introduction
To confirm the USB driver installation
1 Click [Start] --_ ]Settings] --_ [Control
Panel].
2 Click [System].
"System Properties" screen appears.
3 Click ]Hardware] tab.
4 Click ]Device Manager].
"Device Manager" screen appears.
5 Make sure that" SONY DDX-A1000 USB
Device" appears in DVD/CD-ROM
drives, "Generic volume" in Storage
volumes, and "USB Mass Storage
Device" in Universal Serial Bus
controllers respectively.
When all the devices appear, the USB
driver is installed correctly. If any of
these devices are not shown, install the
USB driver again following" If you
cannot install the USB driver" (page 97).
_÷:_ Computer
/p _-ka Diskdrives
/#_ _
Display adapters
DVD CD ROf4 drives
_i_') NEC CD-ROH DRIVE:291
SONY DDX-A1000 USB Device
1_ Floppy is LUFIru er,
[g_ Floppy disk drives
[p*_ IDE ATAIATAPI controllers
i_!::_ Infrared devices
Keyboards
i_i:::_ MonitorsNice and other pointing device_
[#_ _ PCHCIA adapters
[_7 4_ Ports (COM & LPT)
I_ ,,_: Sound, rid .... d g ...... trollers
I<_ Storage volumes
_ Generic volume
5gs_
Universal Serial Bu_ contreller_
• Intel (r) 8244or'4x USB Universal Host Controller
• US[3Mass Stora e Device
For Microsoft Windows Me users
1
Connect the AC adaptor to your
camcorder.
Set the mode dial to [] (Play/Edit).
Turn the power on your camcorder by
sliding the POWER switch upward
while pressing the green button.
Connect the _ (USB) jacks of the
camcorder and the _ (USB) port of the
computer using the USB cable supplied
with your camcorder.
port
USBjack
l_ USB cable
Your computer recognizes the
camcorder, and the "New Hardware
Found" dialog box appears.
5
Follow the instructions given in the on-
screen messages and restart your
computer.
The connection between your
camcorder and the computer is
completed.
4
e.
o-
g
g
¢0
@
O
&
O
95